Off my lazy ass

[tommEE]

Ok, I finally put some info up at http://defconcannonballrun.com and http://moloch.org/cannonball

* There might be errors. I am still double checking
* The sign-up should be working
* Most people have gps phones so get instamapper and iframe stuff to me.
* Volunteers are always welcome at both ends of the race.

more to follow

[Queeg]

Re: Off my lazy ass

yay, its about time. now only if i couldbe around for it. i guess ill be waiting in vegas for you guys. dont know howstuff is going happen so i dont know if ill lbeworking, but ill keep you posted.

[tommEE]

Re: Off my lazy ass

I haven't seen anyone sign up for it and no conversations have been heard either. I wonder if I will have to cancel it for lack of interest.

[shagghie]

Re: Off my lazy ass

It's been awhile since I've done a cannonball...man. Thing is see..I think Black Hat killed the Cannonball Star, b/c I have to be out there for BHB for the day job now...

And after putting SO MUCH WORK into my '93 Corrado too.... you guys wouldn't have stood a chance!

Teaser on some of the parts:

Engine:

Balanced / blueprinted bottom end to a gram
Bildon crank scraper
2.9 kolbenschmidt pistons
All ARP bolts in bottom end
Delo 15/40 Oil (High Zinc Content)
ECS Magnetic Drain Plug
New oil pan
New Oil pump
mk4 head gasket
head from a 2001 VR6 with blocked sai port
All new guides
All new Valves
New TT titanium retainers with high lift valve springs
New TT 268 cams
mk4 upgraded rails / guides with all new chains and tensioners
New Neuspeed lightweight pulleys
European round collar high flow manifold with inscription (rare german
market only B3 Passat)
European 2.9 Throttle body
New TT Stainless 2.5 inch exhaust with borla muffler
New TT Black powder coated tip
New TT High flow cat
New O2 Sensor
ALL New Engine Sensors
New Fuel Pump
New Feul Pressure Regulator
Cleaned and blueprinted injectors
New Fuel Sender
New AC compressor
New Alternator
New Starter
New Passat intake boot
New Neuspeed P-Flow Intake kit
New Bosch Distribuitor
New Coil Pack
New Spark plugs
New Bosch wires
New (Obsolete) New Dimensions Thermostatically Controlled Oil Cooler kit
New OEM Oil cooler
New oil sensors / senders
New Coolant sensors / senders
New Billet crack pipe
New Godspeed aluminum radiator
New low temp thermostat and fan switch
New fan motor
New Fan control module and adapter kit for the mk3 style
New Coolant reservoir
G12 Coolant
New Samco Hose kit
New Heater core
New water pump
New AC compressor
New ac control resistor
New clutch
New Flywheel
New slave
New Master
New Serpentine Belt
New Serpentine Tensioner
New Throttle Cable
New AUX water pump
New Washer Bottle
Custom Techtonics chip made for the build
New interstate Battery
Cloth Re-wrapped engine harness


Drivetrain / Suspension:

Ate Super Blue Racing fluid
Quaife Corrado trans built by Sean at Kraftswerk
New Axles
New SS brake lines
EBC Yellow Stuff pads
Brembo zinc coated drilled and slotted rotors
New Powersteering rack
New ball joints
New PS Lines
New tie rod ends
New Wheel bearings
New Hubs
New Urethane bushings - all the way around
New OEM front engine mount and right mount
New motorsport transmission mount
New Bilstein PSS Coilovers with all new strut mount bushings (rear are urethane)
Neuspeed Short shift Kit
Neuspeed Upper front tie bar
Neuspeed triangulated Rear tie bar


Interior / Exterior:

New ignition switch
New clam shell
New HVAC controls
New Schroth ASM 2 Belts
New Headlight switch
European Fog Light Switch
New Alpine stereo (iDA-X303)
New trunk straps
New hood cable
New Sunroof seal
Black sunroof switch
Momo Steering wheel
Momo Shift knob
New driver's door handle
New Windshield
New Factory windshield moulding
VR6 Ecodes
European Seat belts
Euro Lip
Fk Badgeless grille


Porsche D90 Wheels powder coated high gloss black 16x6F 16x8R
Yokohama S Drives 195.45.16


Compression ratio should be somewhere around 10.7:1
Should have the car out there so let me know if any gear heads wanna take a look after the run. I'll try to make it to the finish line to support if I'm not booked to perform. (doing the Zombie ball and possibly EFF this year).

I'll try to rally some folks from San Diego if I can. Last time I did one we left from here first together. Was a blast!

[eris]

Re: Off my lazy ass

I tried to send you an email to let you know I was available thurs for whatever at the Riv you needed but the mail bounced. Might be your problem with the lack of interest as well.

[theabcasian]

Re: Off my lazy ass

I have a team or two ready to go, pinged you about it last month never got a reply. there have been talks about uavs and cop tracking as well as large radio use in the san diego aria

[tommEE]

Re: Off my lazy ass

I tried to send you an email to let you know I was available thurs for whatever at the Riv you needed but the mail bounced. Might be your problem with the lack of interest as well.

what email address did you use that it bounced from?

[DJ Jackalope]

Re: Off my lazy ass

Shagghie,
are you trying to sell your car again?
did you forget to mention new floor mats an the new car smell?

I So wish I could turn up in LA and join a team early... but right now I can't. :/

[tommEE]

Re: Off my lazy ass

UPDATE:

I gave one of the time clocks to Craig to take it into Vegas. The race is still a go for Thursday. First racer leaves at noon.

[Ray]

Re: Off my lazy ass

Hi,

hm, little information - I hope our Team is registered even though it doesn't show up in the List... Guess we'll find out tomorrow...

Anything online planned besides the instamapper? We'll have IRC on board, I'd suggest a channel with key on efnet?

Not really knowing what to expect tomorrow,
Ray